Tuesday, June 18, 2013

Heart Ring

This is such a simple - yet beautiful ring that anyone can make!  The steps are very easily laid out from ISpyDIY also.  The wire gauge is not labeled, but it looks like aluminum wire.




Instructions after the break...



Supplies: Jewelry Pliers and wire.  

Bend the wire over the far part of the plier to make the first hill of the heart. 
Next make a hard bend at the bottom of the hill.  
The make the second hill. 

Squeeze in the valley between the two hill to make a point
Next bend the wire so it will fit around you finger. 
Cut off the excess wire and bend to make a loop at the end. 

No comments:

Post a Comment